Bail For Pendant In Chicago
Description
Form popularity
FAQ
There's lots of different styles. And imaginative. Ways that this can happen but today i'm going toMoreThere's lots of different styles. And imaginative. Ways that this can happen but today i'm going to show you a traditional way on a piece of cardstock.
And you slide on your pendant. And then you close it back up. So here you just added a decorativeMoreAnd you slide on your pendant. And then you close it back up. So here you just added a decorative element to your jewelry.
The bail is normally placed in the center of the necklace where the pendant hangs. Some bails are made so a pendant can be attached after the necklace production is completed.
Comments Section You have to take it to a jeweler to have the bail change. The loop on the top of the bail would have to be cut off. Then a tiny jump ring facing the same way as the pendant soldered on than a traditional large bail (or large jump ring) for the chain to go through.
The terms "bale" and "bail" are often used interchangeably in jewelry to describe the component that attaches a pendant to a chain, with "bail" being the more commonly used spelling.
Use lots of pressure. And you just want it to swing freely. And then you've got a finished pendant.MoreUse lots of pressure. And you just want it to swing freely. And then you've got a finished pendant. Here are a few other types of ice pick bails here's a folding. One.
There's lots of different styles. And imaginative. Ways that this can happen but today i'm going toMoreThere's lots of different styles. And imaginative. Ways that this can happen but today i'm going to show you a traditional way on a piece of cardstock.
And there are a couple of little picks on the inside here. And you just take your element. Say youMoreAnd there are a couple of little picks on the inside here. And you just take your element. Say you want to make this agate into a finished piece a pendant.
So all you're going to do is very gently. Use your fingers. If you use pliers you might ding up theMoreSo all you're going to do is very gently. Use your fingers. If you use pliers you might ding up the metal. And it's really not necessary it's pretty easy to. Open just gently pull. It.
If you're planning to wear the chain with a pendant, the length should be between 53 and 63cm (22 to 25 inches), slightly longer than a chain that you wear alone. Wearing chains of this length ensures that the pendant falls squarely into the middle of the wearer's chest.