Size Seal Document For Free

Methods of Signing and Sealing. A Professional Engineer may use a wet seal, an embossing seal, or a digital seal. Whichever is used must be at least 1-7/8 inches in diameter and similar in design as indicated in Rule 61G15-23.002, F.A.C., Seals Acceptable to the Board.

Architects may order the seals or stamps from any vendor they choose, so long as they comply with the following requirements: The seal shall be circular in shape and two inches in diameter. Concentric with the outside of the seal there shall be a circle one and three-eights inches in diameter.

Authorize your engineering blueprints and plans with a professional round stamp. Customize this design with your name and licensure number. This design adheres to all Pennsylvania state professional regulations for engineering and is 1-3/4" in diameter.

All professional engineer rubber stamps are made to your state specifications. These engineering seals can vary from 1-5/8" diameter to a 2" inch diameter impression area.

CT Engineer Stamps Authorize your engineering blueprints and plans with a professional embossing seal. Customize this design with your name and licensure number. This design adheres to all Connecticut state professional regulations for engineering and is 1-1/2" in diameter.

Usually, PE stamp sizes range from 1 1/2? to 2? in diameter.

The size of the Virginia Engineer Stamp or Seal must be 2" in diameter. Leading zeros may be omitted from the State of Virginia Engineer Stamp if desired but the format must have 'Lic. No. ' in front of the number.

About the Seal The seal should be an inch and a half in diameter, and it must include your name or the name of your company, your certificate number, and the phrase ?Registered Professional Engineer.? The seal will be circular, and the diameter of the inner circle should be 1".