Allow Signed Fleet Inspection For Free

If the previous driver has noted any defects on a DVIR, the driver doing the pre-trip must sign the DVIR agreeing that the repairs were completed. If the repairs were not completed, the driver must sign that he/she agrees that the repairs are not necessary.

Defect Protocol If a driver discovers a defect during his/her post-trip inspection, that driver must complete and sign the DVIR and submit it. FMCSA-required specifications govern the routing of DVIRs with defects. Before the vehicle can be operated again, the carrier must address the defect.

DVIR, an acronym that stands for Driver Vehicle Inspection Report, is something that all drivers of commercial vehicles need to conduct twice a day. A DVIR consists of a pre-inspection and post-inspection to check the state of the vehicle before and after the trip.

First, check that parking brakes are on and/or wheels are chocked. You may have to raise the hood, tilt the cab (secure loose things so they do not fall and break something), or open the engine compartment door.

Why is a DVIR Required? The ultimate goal is to reduce the number of crashes, injuries, and fatalities involving commercial vehicles. DVIRs help ensure a vehicle is in a safe and optimal condition before and after each trip. This provides a safe environment for the driver and anyone around the vehicle.

Level 1: North American Standard Inspection The level one DOT inspection is the most common level of DOT inspections, and the most thorough. This level of inspection includes a complete check of both the driver and the vehicle.

The DVIR is the formal record that confirms a driver has inspected their commercial motor vehicle (CMV) before and after taking it out on the road. These are called pre-trip and post-trip inspections. Drivers must complete a DVIR for each vehicle every day of its use.

Who has to sign the DVIR? In all cases, the driver who prepared it must sign it. This is the only signature required if no defects are noted. If a defect was noted, then a mechanic or other company official must sign it to indicate either that the vehicle has been repaired or that repairs are unnecessary.

Technicians need a certain amount of experience and qualifications to perform BIT inspections. You need to either: Complete a state or federal training program and have a certificate from a state or Canadian province that qualifies the holder to perform a vehicle safety inspection?