Get Model 1000 Testa N Drain

Measure water pressure It's typically 2 inches in size and what's used to drain the system. Technicians will then measure the water pressure using the gauges installed on the riser while the 2-inch main drain is flowing. The gauge confirms proper water pressure in order for the fire sprinkler system to work properly.

The Inspector'sTEST products are designed to perform the required sprinkler system's alarm and water flow test. They can also be utilized to test the opening of a dry-pipe or preaction valve and the trip time from when the valve is opened until the arrival of water at the furthest point in the system.

These valves are used for testing and maintenance of sprinkler systems. By means of the orifice of different sizes inside it, it creates a flow equal to the flow passing through only one sprinkler, and in case of a sprinkler water flow, it is ensured that the alarm devices in the lines are tested for control purposes.

A Test and Drain is a type of valve with both a test function and an express drain function. Think of a ball valve and inspector's test valve combination, except it's manufactured as one unit, making it much more convenient.

Drain valves allow excess water vapor to exit the tank and reach the atmosphere. Condensation buildup can result in corrosion that damages the compressor, shortening its life span. By removing the extra moisture, you reduce wear on equipment powered by compressed air systems.

It is used to conduct testing and maintenance on sprinkler systems. With the orifice in different sizes inside, it creates a flow equivalent to the flow passing along one sprinkler only and enables tests of alarm devices on the lines for checking purposes in the case of sprinkler water flow.

A ball valve with a drain port helps release unwanted or excessive fluid from a pipeline. The valve allows for easy draining of the contents of a pipeline or tank without having to remove the entire valve.

A tubing test valve enables the tubing string to be integrity tested as it is run into the well. Once the final test has been performed, the tubing test valve is locked open for the remainder of the test. Most tubing test valves are locked open by the application of annulus pressure.

Zone Control Valve is a system designed to separate the area in case of maintenance and to get the indication of fire zone on a combination of Butterfly valve, Flow Switch, Pressure Gauge and Test & Drain Valves.