Get Pre-desorption Well Site Information Check List - Usgs

The Pre-desorption Well Site Information Check List - USGS is a crucial document for operators looking to provide comprehensive information about their well sites. This guide will help you navigate the online form filling process, ensuring you complete each section accurately and efficiently.

Follow the steps to complete the Pre-desorption Well Site Information Check List - USGS online.

1. Press the ‘Get Form’ button to obtain the Pre-desorption Well Site Information Check List - USGS and open it in the designated editor.
2. Begin filling out the form by entering the 'Well Name', 'Operator', and 'Lease' information. Ensure you provide accurate details for each category.
3. Continue to section I.A and enter the 'Location', 'Latitude', and 'Longitude'. Make sure the geographical coordinates are correctly formatted for clarity.
4. In section I.B, input the 'Elevation' data, including 'Ground' and 'Kelly Bushing' measurements, followed by the 'State', 'County', and 'Country' details.
5. For I.C, enter the 'API number' and 'Well permit number'. Verify these numbers with your records to avoid discrepancies.
6. Section I.D requires you to provide the 'Township', 'Range', 'Section', '¼ section', and 'Baseline'. Check local maps to confirm these details.
7. Input the 'USGS Quadrangle' and 'USGS Geologic Map' in section I.E. If unsure, consult relevant geological resources.
8. Fill section I.F regarding 'Rig road conditions'. Indicate if a 4x4 vehicle is required, suggested, or not needed.
9. In section I.G, detail directions to the site from a well-known point to aid in locating your well.
10. Proceed to section II and record the expected 'Net coal thickness' and canister spacing in II.A. Calculate the number of cans needed based on your spacing.
11. In II.B, document the number of coal layers and the approximate cans required for drill cuttings.
12. List core points in II.C with their respective depths. This information is crucial for your drilling strategy.
13. Specify the 'Core diameter' in section II.D, ensuring it meets the requirement of being slightly less than the canister inner diameter.
14. Indicate in II.E the type of drilling bit used and clarify whether it is vertical or directional.
15. Assess availability of logs and nearby well data in II.F and provide the name of the nearby well.
16. Document ballast temperatures if available in II.G, including BHT or DST measurements.
17. Move to section III to note drilling schedules and temperatures under III.A, indicating spud date and expected duration.
18. Identify the mud loggers in III.B and provide their contact information. Note if geolographs or gas detectors are present.
19. In III.C to III.E, provide names and contact numbers for the well site geologist, company representative, and tool pusher.
20. For III.F, ensure basic requirements for cuttings handling and access are met as indicated.
21. Section IV covers local supplies. Provide contact information for welding supplies, hardware stores, motels, restaurants, and local airports.
22. Fill out the shipping address for the well site in section V.
23. Lastly, use section VI for any additional notes that may assist understanding or provide context for the data entered.
24. Review all entries for accuracy, then save your changes, download a copy, or print the completed form.

Complete your Pre-desorption Well Site Information Check List - USGS online efficiently and ensure all necessary information is accurately recorded.