Get Hoover Spinscrub 50 Manual

Clean hair from brush heads with a soft-bristled brush or comb. Soak the attachments in soapy water for 30 minutes, wash with a lint-free microfiber cloth and then rinse under hot tap water. Place your attachments on a dry towel to air-dry.

If the cleaner is still not spraying despite the water and detergent tanks being full, there may be a bubble of air stuck in the pump or the hose. To fix this, you need to turn the cleaner on and lower the hose down to the floor. Next, prime the pump by holding down the trigger for up to 1 minute.

If the cleaner is still not spraying despite the water and detergent tanks being full, there may be a bubble of air stuck in the pump or the hose. To fix this, you need to turn the cleaner on and lower the hose down to the floor. Next, prime the pump by holding down the trigger for up to 1 minute.

The vinegar and hot water solution will neutralize the odor and remove it. ... Using vinegar in a Hoover steam cleaner helps reduce soap bubbles from forming in the cleaning machine and helps remove odors from your carpet, upholstery, and other surfaces.

If your Hoover Steamvac was working properly and suddenly it is not sucking any water, nine times out of ten, the culprit is the lid on the lower recovery tank. The lid on the lower tank (or dirty water tank) needs to hinge at the front and snap down at the back in order to creat a proper seal.

Step 1: Detach the brush from the carpet cleaner. It is not easy to clean the brush while it is still attached to the vacuum cleaner. ... Step 2: Wash the brush. ... Step 3: wipe the brush with diluted vinegar. ... Step 4: Leave the brush to dry.

Grasp the nozzle in one hand and hold it up slightly at an angle, so that you can slide the T-shaped end of the nozzle-cleaning tool inside to remove debris. Slide the tool up and then right or left and down, to pull the clog out of the nozzle. Repeat as needed, until you've completely cleaned out the nozzle.

It's possible your pump may have lost its prime. To check, turn off machine and hold the spray trigger for 30 seconds. ... Your pump belt could be broken. To check, turn the power off and unplug from the outlet, insert a flat head screwdriver in to the slot of the belt access door to release.

Lift the tab on top of the upper tank and pull the tank away from the vacuum. ... Press on the foot release pedal on the rear of the steamer with your foot, and lower the handle fully. ... Rotate the handle on top of the tank toward the rear to unlock the lid.