Get Oil Drain Plug Torque Chart 2020

Run the plug down with your hand until it stops flush with the oil pan. With a wrench tighten the plug very lightly until it stops and is only snug with the pan. Then tighten the plug 1/4 turn. That's it your done.

Run the plug down with your hand until it stops flush with the oil pan. With a wrench tighten the plug very lightly until it stops and is only snug with the pan. Then tighten the plug 1/4 turn. That's it your done.

If you over-tighten the drain plug, you can strip the threads. And while it's harder to do, you can damage the rubber gasket atop the oil filter if you really overtighten it. Most likely, though, it's just going to make it really difficult for the next guy to remove the plug and filter.

you don't have to be exact with torque ... 30-36 ft lbs would be fine with your drain plug. to keep things in perspective, if this is your first oil change on this car, then there would have been at least one oil changer that ran your drain plug down with an impact, and probably no one used a torque wrench.

The oil drain plug may be a basic drain plug, but the torque amount will be different. The typical torque specification for oil drain plugs on an aluminum oil pan is 20 to 25 foot-pounds.

Engine oil pan bolts range in torque from seven foot-pounds to 22 ft-lb or more for large engines with heavier pans and bolts. Once you've torqued the bolts and filled the engine with oil, you should run the engine for five minutes to bring it up to normal operating temperature.

Run the plug down with your hand until it stops flush with the oil pan. With a wrench tighten the plug very lightly until it stops and is only snug with the pan. Then tighten the plug 1/4 turn. That's it your done.