Get Measuring Guide For Basco Shower Doors From The Shower Door Store Use This Guide To Get Accurate

Determine the distance from the top of the tub edge or shower base to the top of the wall unit or tile wall where you want the door to be located. Measure vertically at both sides. The measurement should be to the nearest 1/16-inch. Select a door with a height less than or equal to the smallest of these measurements.

the shower glass thickness? The glass will have a tapered edge, so always measure to the farthest points on the side of the glass. Since the tape measure has a metal clip attached to the end, its always better to start measuring at the 1 or 2 mark.

For a custom frameless glass shower door (the best option, in our opinion), you're likely looking at spending somewhere between $900 and $1,300 for a door and panel. The average comes in right around $1,000, and the installation is usually about $300 on top of that.

Pivot Door A pivot shower door is a swinging door that has a pivot hinge allowing the door to open in either direction. Pivot shower doors can swing 180° so they can open in or out. The pivot hinge can be attached on one side of the door, or it can be center-mounted to create a revolving shower door.

Using your tape measure, measure lengthwise across the bottom, center, and top of your shower for an inline opening. When measuring for openings with a return, measure at the center of the curb (the centerline). Remember to account for the body of the measuring tape so that your measurements are completely accurate.

Determine the distance from the top of the tub edge or shower base to the top of the wall unit or tile wall where you want the door to be located. Measure vertically at both sides. The measurement should be to the nearest 1/16-inch. Select a door with a height less than or equal to the smallest of these measurements.

Using your tape measure, measure lengthwise across the bottom, center, and top of your shower for an inline opening. When measuring for openings with a return, measure at the center of the curb (the centerline). Remember to account for the body of the measuring tape so that your measurements are completely accurate.

Typically, most shower doors have a height of 72 inches in length, and the width is usually between 36 to 40 inches. Of course, you may have a custom shower door set up with varying lengths, thickness, and weight.

Shower Door ReplacementReplacing just the door can make a big difference in the overall appearance of your shower, one of the most important parts of a bathroom. Replacing your old shower door with a new piece can save on the large cost of ripping out your entire shower's base and walls.

The shower enclosure must permit unobstructed access to a showering person in case of a fall. However, your shower door can open in both directions, outward-opening and inward-swinging. You'll need about 30" of clearance space outside your shower to install a swinging shower door.