Get Fl 402-2010 2010-2026

Filling out the FL 402-2010 is essential for demonstrating compliance with the Florida Building Code regarding energy conservation for residential buildings. This guide provides clear, step-by-step instructions to assist users in accurately completing the form online.

Follow the steps to successfully complete the form.

1. Click the ‘Get Form’ button to obtain the FL 402-2010 and open it in your preferred document editor.
2. Begin by selecting the type of construction. Indicate whether it is new construction, an addition, or related to an existing building.
3. Specify the type of residence, choosing between single-family detached or multiple-family attached. If indicating multiple-family, also enter the number of units covered by this form.
4. Answer whether the submission represents a worst-case scenario by selecting 'yes' or 'no'.
5. Provide the conditioned floor area in square feet. This is important for compliance calculations.
6. Fill in the details regarding glass types and areas. Provide the U-factor, SHGC (solar heat gain coefficient), and the percentage of glass compared to the floor area.
7. Complete the section on floor type, including the area and R-value insulation for various floor types.
8. Continue by completing the wall type, area, and insulation details. Fill in both the exterior and adjacent wall details as applicable.
9. Provide information about the ceiling type, area, and insulation, indicating any specific R-values.
10. Document details of the air distribution system, including duct insulation and test reports as required.
11. List the cooling system specifications, including the type and efficiency.
12. Indicate the heating system type along with its efficiency rating.
13. Attach the HVAC sizing calculation and ensure it adheres to Florida code compliance.
14. Complete the section on hot water system specifications, including any energy efficiency measures.
15. Review the form for completeness, then print or save the document. Finally, ensure the 'Prepared By' certification statement is signed and dated by the owner or authorized agent.

Complete your FL 402-2010 form online today to ensure compliance with energy efficiency standards.