Get Users Guide: Wyse Usb Firmware Tool 1.19.0.4

Delete key Press and hold the Delete key to enter the BIOS settings on the ThinOS clients with Wyse BIOS. F2 key Press and hold the F2 key to enter the BIOS settings on the ThinOS clients with Dell Standard BIOS.

A quick and easy way to re-image a Dell Wyse thin client, especially Windows 10 IoT/Embedded devices, is to use the Wyse USB Firmware Tool. The tool is also used to re-image other models of Dell Wyse thin clients as well but not as often.

From the desktop menu, click System Setup, and then click Remote Connections. The Remote Connections dialog box is displayed. Select Broker type from the drop-down list. If you select None from the list, click either of the following connection protocols: ... Click OK to save the settings.

Enter the IP address or FQDN of the VNC server which you want to connect. Enter the password to log in to the remote VNC Server. Click the ON/OFF button to enable or disable this option. If enabled, the connection is automatically connected after you log in to your thin client.

High-privileged or stand-alone users can reset the thin client to factory default settings using the G-key reset feature. To reset the thin client to factory default settings, restart the thin client and continuously tap the G key during the restart process.

Follow the procedure in Before working inside your thin client. Loosen the thumb screw that secures the chassis cover to the thin client. Figure 1. ... Slide the cover towards the front of the system to disengage the tabs from the guide slots on the thin client. Figure 2. ... Lift the cover away from the thin client.

Right when the you see the WYSE logo, press Ctrl + ESC. A prompt will ask for the username and password, BUT right below that there is a Admin Mode button that I press in order to get into the Administrator Mode.

Power on the Wyse device and immediately hit the Del key to bring up the bios setup. Enter the password Fireport Change the boot order sequence to allow USB Floppy and USB Hard disks to be at the top of the boot order. Save you changes and exit. F10

Verify the Wyse unit is powered off. Insert USB stick with Wyse USB firmware tool installed and configured**. Power on the Wyse thin client. At the Dell splash screen, press the key "DEL" Enter Bios Password (Fireport) In Bios enable: "advanced = Boot from USB"