Feature Line Permit For Free

Grading: Fun with Feature Lines - YouTube YouTube Start of suggested clip End of suggested clip Let's take a look at the elevations of that feature line if we go to the editor. So the top where weMoreLet's take a look at the elevations of that feature line if we go to the editor. So the top where we started was 809. And we were grading. Down about -3 that was a natural slope there roughly.

Extracting Objects from a Surface in Civil 3D 2018, 2019, 2020, 2021 YouTube Start of suggested clip End of suggested clip Now what you'll see is that if we click on our watershed. Now it's created AutoCAD objects from eachMoreNow what you'll see is that if we click on our watershed. Now it's created AutoCAD objects from each of the watersheds. Within the drawing.

In the drawing, select a feature line, right-click, and click Edit Feature Line Style. In the Feature Line Style dialog box, specify the feature line style components.

To Extract Feature Lines From a Corridor Click Home tab Create Design panel Feature Line drop-down Feature Lines From Corridor Find.Do one of the following:Use the options in the Extract Corridor Feature Lines dialog box to specify settings and to refine the selection of feature lines.

Feature lines are 3D objects which can be used as grading footprints, surface breaklines, and as corridor baselines.

To Break a Feature Line Click Modify tab Edit Geometry panel Break Find. Select the feature line to break: Specify the second break point. Note: if you enter the @ character at the prompt for the second break point, it uses the first point location, creating a break without a gap.

Use the Break command to break a feature line into two feature lines. The prompts for this command are similar to the AutoCAD Break command. Click two points to specify both sides of the break.

So this is the edge of the gutter, the flow line, the top face, and the top back. So that's what Feature Lines do, they represent edges or linear objects in a three dimensional form in your drawing model.

Use this command to trim feature lines so that they end precisely at boundary edges defined by other objects. Click Modify tab Edit Geometry panel Trim Find. Select the objects to serve as cutting edges. Select the feature line(s) to trim.

Fillets a feature line, survey figure, or 3D polyline. This command can be used to round the corners of feature lines. The fillet can span multiple segments and can be used to join two connecting feature lines.