Get Lead And Copper Sampling Instructions.doc

This guide provides clear and professional instructions on how to fill out the LEAD AND COPPER SAMPLING INSTRUCTIONS.doc form online. Each step ensures that you understand how to properly collect lead and copper samples as required, helping you to maintain compliance and ensure safe drinking water.

Follow the steps to complete the lead and copper sampling instructions form effectively.

1. Press the ‘Get Form’ button to access the document and open it in your chosen online editor.
2. Review the sampling requirements outlined in the document. Ensure samples are collected from different locations where water may be consumed, such as drinking fountains and sinks.
3. Confirm that all samples have a minimum stand time of 6 hours before collection, and do not collect samples consecutively from the same site.
4. Start the sampling process by running the cold water tap at each designated location to flush the line completely before sampling.
5. Turn off the tap and ensure it is taped off to prevent use for at least 6 hours. This is critical for maintaining accurate sampling conditions.
6. Do not remove the faucet aerator, as it is essential for proper collection of the 1st draw sample.
7. If sampling from a faucet with a water softener, make a note of this on the laboratory paperwork to ensure accurate analysis.
8. After the 6-hour stand time, position the sample bottle to collect the 1st draw immediately when the faucet is turned on.
9. Seal the sample bottle tightly and document the time of sample collection on the chain of custody form.
10. Ensure all required samples are collected in the same manner and submit them for analysis within 14 days.
11. Complete the laboratory paperwork thoroughly and submit it along with your samples.
12. Utilize the provided space for recording the name, address, and time of sample collection for your convenience.

Begin completing your LEAD AND COPPER SAMPLING INSTRUCTIONS.doc form online today!