Get Raypak Heating Boiler Pre-startup Checklist 2012-2025

Boiler shall be inspected and hydraulically tested to 1.25 times (or 1.5 times in case of major repair) of the maximum working pressure. Inspector/Competent person (Third Party) prepares inspection report at site and hand over a copy to the owner or his representative.

Weekly maintenance checklist Check the boiler for leaks including water, steam, and exhaust gases. Check operating controls to ensure normal functioning. Check indicators and safety features to ensure they are working properly. Check for unusual noises and vibrations.

From a safety perspective, the safety valve is arguably the most important part of a boiler and will be an important device to review during a boiler inspection. If a problem develops in the boiler, the safety valve (also called the Relief Valve) will help prevent over-pressurization, which can lead to an explosion.

Boiler Maintenance Checklist Inspect and clean fireside surfaces. Inspect all burner refractory material. Inspect all manhole gaskets for leaks. Inspect and test all system valves. Inspect and test all safety valves. Clean and rebuild low water cut-off. Recalibrate all operating controls. Overhaul feed water pumps.

Boiler Room Checklist at Startup Make sure to verify water level in boiler. Inspect all manual and automatic controls regulating feed water, dampers draft, as well as interlocks. Make sure every stack damper is open. Inspect flame detection equipment. Check flue passes and the furnace for fuel accumulation.

Daily Operation Check the boiler steam pressure and the water level. Check that the feed water control system is operational. Check the boiler water condition and make necessary countermeasures with regard to the feed and boiler water treatment. If necessary blow-down the boiler.