Get Ivy Rain Barrel Installation Instructions. - Rain Barrel Program - Rainbarrelprogram

2:06 4:05 How to : Rain Barrel Linking Kit - YouTube YouTube Start of suggested clip End of suggested clip And a nut so you want to make sure the gasket's installed on the main body. And it goes on theMoreAnd a nut so you want to make sure the gasket's installed on the main body. And it goes on the inside of the rain barrel to seal on the inside. Face so i'll the first. One.

Rain barrels are usually positioned below the downspout of a roof gutter; however, you can still use a rain barrel if your house doesn't have gutters. You can also attach several rain barrels together with a simple connection kit.

Typically, rain barrels are elevated 12 to 36 inches above the ground. This creates enough pressure to move water through a spigot to fill a watering can or hose or use drip irrigation. For every 1 foot of elevation, you gain approximately 0.4 pounds of pressure (PSI).

Step 1-To Assemble Bottom Drain Spigot. Remove the plastic cap and ONE rubber washer. ... Step 2-Assemble Top Overflow Valve. Remove plastic cap and ONE rubber washer. ... Step 3-(Assemble the Extra White Spigot. Step 4-Assemble the Rain Barrel Frame. Insert all the poles into the slot openings on the bottom of the rain barrel.

I prep the ground under where the rain barrel will be with a thick layer of mulch. Mulch helps absorb any excess water that might come from the barrel or spigot during use. I put a layer of solid concrete pavers on the mulch to create a nice level platform.

Instead, use a robust nylon ratchet strap, available at most automotive stores. The nylon is exceedingly strong, and won't damage your barrels. Ratchets make for easy installation, as you can tighten the strap down after securing the anchors at the wall, and make adjustments over time if needed.

Typically, rain barrels are elevated 12 to 36 inches above the ground. This creates enough pressure to move water through a spigot to fill a watering can or hose or use drip irrigation. For every 1 foot of elevation, you gain approximately 0.4 pounds of pressure (PSI).

2:21 3:54 How To A Rain Barrel - YouTube YouTube Start of suggested clip End of suggested clip Before you cut because this is the point of no return put on your safety goggles. And gloves and cutMoreBefore you cut because this is the point of no return put on your safety goggles. And gloves and cut the downspout with a hacksaw or tin snips connect a diverter to the cut downspout.