Get Pump Application Form - Dalco Pumps

The Pump Application Form from Dalco Pumps is essential for ensuring proper pump selection based on your specific requirements. This guide will provide you with step-by-step instructions to complete the form accurately and efficiently online.

Follow the steps to complete the form with ease.

1. Click ‘Get Form’ button to access the application form and open it in your editor.
2. Begin by completing the Fluid Data section. Specify the fluid type and its percentage concentration, along with the boiling point. Include the pumping temperature, minimum and maximum temperatures, viscosity, specific gravity, and any other relevant physical and chemical properties.
3. Next, move on to the Performance Data section. Indicate the flow rate, whether it is normal, minimum, or maximum. Specify suction details, suction pressure, NPSHA, and discharge pressure. Make sure to provide these measurements in the specified units.
4. In the Motor Data section, select the type of motor you plan to use (AC, DC, or air motor). Fill in the motor power, speed, frequency, and enclosure type. Specify the NEMA or IEC frame and provide voltage details.
5. Fill out the Location Data section. Note whether the pump will be indoors or outdoors and provide the ambient temperature range. Indicate the elevation and the hazardous classification, if applicable.
6. Lastly, you can include any additional comments or notes in the comments section. This is your opportunity to provide any other relevant details that may assist in the pump selection process.
7. After all sections are completed, you can save your changes, download the form, print it, or share it as needed.

Complete your Pump Application Form online today for efficient pump selection!