Get CALIBRATION REPORT FOR PORTABLE ELECTRONIC THERMOMETER PET

There are two common methods for thermometer calibration in food service: the boiling point method and the freezing point method.

However, the simplest way to help calibrate a non-contact thermometer is to create an ice bath for the thermometer to measure. Luckily, this can be done by using a large glass rather than having to fill up an entire bathtub.

0:25 2:20 Calibrating a Thermometer - YouTube YouTube Start of suggested clip End of suggested clip Water some thermometers can be calibrated check the package for instructions. To use the ice waterMoreWater some thermometers can be calibrated check the package for instructions. To use the ice water method fill a large glass with ice. Add clean tap water to the top of the ice and stir.

There are two common methods for thermometer calibration in food service: the boiling point method and the freezing point method.

The ice bath test is the easiest way to test a thermometer for accuracy, assuming your thermometer will display temperatures of 32°F or less. The advantage of this method is that an accurate thermometer will always read 32°F in a properly made ice bath regardless of altitude or atmospheric pressure.

0:14 2:20 How to Calibrate Digital Thermometers | eTundra - YouTube YouTube Start of suggested clip End of suggested clip Button i want to hold that down for about 8 seconds. And then it's going to start to flash cal forMoreButton i want to hold that down for about 8 seconds. And then it's going to start to flash cal for about two seconds that means it's recalibrating. Now we get a new reading of exactly 32 degrees.

Fill a tall glass with ice and add cold water. Place and hold the thermometer in the ice water for 30 seconds without touching the sides or bottom of the glass. If the thermometer is a dial thermometer, allow 1-2 minutes for temperature calibration.

Fill a large container with crushed ice, and then add clean cold tap water until container is full. Stir. Place the thermometer stem/probe into the ice water. Make sure the thermometer is not touching bottom or sides of the glass Hold the thermometer by its top for 30 seconds or until the reading stays steady.