Get Guide For Completing Data Reports

This guide provides step-by-step instructions for completing the Guide For Completing Data Reports. By following these clear and user-friendly steps, you can ensure that your data reports are submitted accurately and in compliance with all necessary regulations.

Follow the steps to successfully complete the data report form online.

1. Click the ‘Get Form’ button to obtain the data report form and open it in your preferred editing application.
2. Begin by entering the manufacturer’s complete name and physical address, including the postal code, on Line 1 of the form as authorized by ASME and the National Board.
3. Record the National Board commission number and appropriate endorsements, as required, to facilitate proper registration.
4. Ensure that all data is entered either completely typed or handwritten, with typed entries not containing any handwritten additions unless they are appropriately initialed and dated.
5. Complete all specific sections of the form, including unique identifiers such as the sequential numbering for items stamped after hydrostatic testing, starting with #1.
6. Indicate the applicable code case numbers and the edition year of the code to which the pressure equipment was manufactured, including any necessary addenda dates.
7. Designate the materials of construction using the correct classifications, and note any exemptions from testing requirements in the 'Remarks' section if applicable.
8. Include all required signatures dated in ink by both the manufacturer’s representative and the authorized inspector.
9. If additional data is needed, use appropriate ASME approved supplementary sheets and reference any partial data reports, attaching them to the primary report.
10. Finally, verify the entire document for legibility, ensuring the font size meets specified requirements, and save, download, print, or share the completed form as needed before submission.

Start filling out your data report online today to ensure timely and accurate submissions!