Get Schumacher Sc1305 Manual

Available charge settings are: voltage (6 or 12 volts); amperage (2, 10, 30, 40, 60 amps); charge time (0 to 160 minutes).

Hooking up the Battery Charger Hook-up the positive cable on the charger to the positive terminal on the battery. Hook up the negative cable on the charger to the negative terminal on the battery. Set the charger to the slowest charge rate.

Place battery in a well-ventilated area. Clean the battery terminals. Connect the battery, following the. precautions listed in sections 6 and 7. Connect the charger to the electrical. outlet. Select the desired rate. When charging is complete, disconnect the charger from the AC. ... A marine (boat) battery must be.

What should a battery charger read when fully charged. On the 12 amp charging setting, the needle will settle at around 6 amps, or just under. This is showing that the battery is fully charged. On the 2 amp setting, the needle will settle near the end of the small red triangle.

With the charger unplugged from the. AC outlet, connect the charger to the. battery, following the instructions given. in the CHARGING A BATTERY IN THE. ... With the charger plugged in and connected. to the battery of the vehicle, set the rate. selection to the Engine Start position. Crank the engine until it starts or 3.

The engine start/cranking assist feature on your charger is for short duration only (typically 3 to 5 seconds ON and 5 minutes OFF maximum). See the front panel of your charger for the recommended crank time your charger allows. Charge the battery for 15 minutes before using engine start/cranking assist.

Plug the Schumacher battery charger into an electrical outlet. Switch the charger on, and charging will commence. Your battery will be fully charged when the charger shows a green light.

Plug the Schumacher battery charger into an electrical outlet. Switch the charger on, and charging will commence. Your battery will be fully charged when the charger shows a green light.

Always read the owner's manual and manufacturer instructions first! Turn the car off. Make sure the battery charger is off and unplugged. Connect the red clamp to the positive terminal. Connect the black clamp to a grounded metal, the car's frame or engine block.