Get Brinks Safe Model 5050 Manual

Open a Fire Safe If you can't get a Brinks safe key replacement, your only choice may be to break the lock. There are a variety of ways to do this, starting with inserting the pointed tip into the keyhole and jiggling it until the lock pops.

Spin the dial a couple of times to reset the lock. Set the dial to zero ("0"). Turn the dial four full clockwise turns. ... Rotate the dial counter-clockwise twice. ... Rotate the dial clockwise once and stop on the third number of the combination on the second turn. Rotate the dial counter-clockwise to the fourth number.

If you've forgotten your passcode, you can reset it by using a thin rod or wire to press the reset button on the inside of the door panel. If all else fails, you can try breaking open the lock or drilling through the override key slot.

Locate the model and serial numbers on your safe and write them down. ... Write down the key number for your safe. ... Contact Honeywell customer support at 877-354-5457. ... Explain your situation to the representative and provide them with the safe identification information and your contact information.

Call the Safe company. Call the safe company. Some company customer service departments will give you your combination based on the serial number and your proof of ownership. You may need to provide a notarized letter stating that you are the owner of the safe.

Turn the dial counter clock wise and pass the second number of the combination once. While still turing the dial clockwise, stop on the second number the second time you reach it. Turn counter clockwise once more and stop on the final number the first time you see it. From there it should be open.

Spin the dial a couple of times to reset the lock. Set the dial to zero ("0"). Turn the dial four full clockwise turns. ... Rotate the dial counter-clockwise twice. ... Rotate the dial clockwise once and stop on the third number of the combination on the second turn. Rotate the dial counter-clockwise to the fourth number.

Enter your old passcode, followed by the "A" key and turn the handle to open your Brinks safe. Find the red memory button inside your safe. ... Enter your new passcode on the keypad. ... Press the 'B" key after entering your new passcode. ... Leave the safe door open and push the safe's handle into the lock position.

Enter your old passcode, followed by the "A" key and turn the handle to open your Brinks safe. Find the red memory button inside your safe. ... Enter your new passcode on the keypad. ... Press the 'B" key after entering your new passcode. ... Leave the safe door open and push the safe's handle into the lock position.

Open the safe using the current combination. ... Press the memory button. ... Enter the new preferred combination in numbers between 3 and 8 only, then press B. Listen for two beeps and watch for the LED light to illuminate. Keep the door open and press down the lock handle. ... Type in the new combination in the safe.

Answer: When you first take the lock out of the package, the combination is, "0000." Enter this combination and then slide the notch in the back of the lock up and to the left. Once you do that, set your new combination, then slide the notch to the right and down. Now your Brinks Lock is reset.

Lay the safe flat on a surface so you can easily access the lock. Insert the tip of the screwdriver where you would normally put the key. Turn the screwdriver counter-clockwise until the lock releases. Straighten out a paper clip, if the screwdriver didn't release the lock.