Get Stanley Stud Finder Stht77403 Manual

If the tool blinks and beeps continuously, there is a calibration error. Try scanning the wall again, but start in a different location. Use DeepScan® mode only if you need it. Using this feature on a regular thickness wall will cause the unit to read studs a bit too wide.

1:28 4:28 How To Use A Stud Finder Simple Easy - YouTube YouTube Start of suggested clip End of suggested clip Towards the electrical box and remember this could be an outlet or where it can be a switch. Once.MoreTowards the electrical box and remember this could be an outlet or where it can be a switch. Once. We notice that the stud finder beeps. It means we found the first edge.

0:15 1:09 Zircon Tip Minute 5: Avoiding False Positives With Stud Finder When ... YouTube Start of suggested clip End of suggested clip Anything in between studs. Could be a pipe or a wire studs will run the height of the wall whereasMoreAnything in between studs. Could be a pipe or a wire studs will run the height of the wall whereas pipes wires. And conduit. Can change direction studs should all be one and a half to two inches wide.

Press and hold the On button. All indicators on the LCD are displayed while the unit goes through it's 1 to 3 second calibration cycle. The word CALIBRATING will appear on LCD (illustration 4) while the unit is calibrating to surface.

1) Check Your Battery. If your stud finder worked previously, but no longer seems to work, about 9 times out of 10, the problem is a weak battery. You may swear that the battery is still good, but it's not. Is the battery new from the store or new from the drawer?

0:10 1:42 Stanley Stud Sensor 150 - YouTube YouTube Start of suggested clip End of suggested clip Yeah it's there's a first bit it is this pad so you will line put mark on it. And then when it stopMoreYeah it's there's a first bit it is this pad so you will line put mark on it. And then when it stop you see that this area is the first line of the start. And then is the last end of the start.