Get Case 188/207d Torque & Rebuild Specifications

This guide provides clear instructions on how to complete the Case 188/207D Torque & Rebuild Specifications form online. Follow each step to ensure that you accurately fill out all necessary information.

Follow the steps to complete the form accurately:

1. Press the ‘Get Form’ button to access the form and open it in your preferred editor.
2. Begin by filling in the liner height above block deck, ensuring the measurement indicates between .001 and .005 inches.
3. Next, enter the connecting rod torque, which should be set between 45 and 50 foot-pounds.
4. Proceed to specify the main cap torque, which needs to be between 90 and 100 foot-pounds.
5. Document the crankshaft end-play, making sure it is between .001 and .015 inches.
6. For cylinder head torque, lubricate all cylinder head cap screws and nuts with clean SAE 30 engine oil. Then fill in the torque specifications based on the type of fasteners used: for grade 8 12-point bolts, enter 75 foot-pounds and 115 foot-pounds where applicable.
7. If using nuts with washers, indicate 60 foot-pounds and 100 foot-pounds respectively.
8. For flanged nuts, record 60 foot-pounds and 95 foot-pounds.
9. After you run in the engine, remember to re-torque the head gasket by loosening each nut and bolt in sequence by a quarter turn and then re-torquing to the specifications provided.
10. Fill in the rocker arm shaft clamps with a torque setting of 25 to 30 foot-pounds.
11. Lastly, set the valve lash to the following specifications when cold: intake at .012 inches and exhaust at .014 inches.
12. Once all fields are completed, you can save your changes, download the form for your records, print a copy, or share it as needed.

Complete your documents online today for efficiency and accuracy.