Get Monopulse Beacon Test Set (mbts) System Calibration Procedure

The MONOPULSE BEACON TEST SET (MBTS) SYSTEM CALIBRATION PROCEDURE is a critical document for ensuring the accuracy of the MBTS performance. This guide will provide step-by-step instructions for completing the form online, facilitating a seamless calibration process.

Follow the steps to fill out the MBTS system calibration procedure form effectively.

1. Click ‘Get Form’ button to access the form and open it in your preferred online editor.
2. Begin by reviewing the introduction section, which outlines the importance of verifying the MBTS output signal level annually.
3. Proceed to the MBTS system setup section. Ensure that you gather all required equipment and documents as mentioned in the list.
4. Fill in the equipment details, including the serial numbers and status of the MBTS and HP-8902 Measuring Receiver,
5. Complete the instrument connections and settings section by carefully following the configuration requirements outlined.
6. If applicable, document any adjustments made to the MBTS configuration settings.
7. Detail the initialization and warm-up process of the MBTS system, capturing the key steps in the form.
8. Verify the output levels using the provided calibration verification methods, and record any necessary measurements.
9. Once all steps are documented, ensure you complete the outputs level calibration section as per instructions.
10. Finally, review all entries for accuracy before saving your changes, downloading, printing, or sharing the form.

Complete the MONOPULSE BEACON TEST SET calibration procedure online to ensure your system’s accuracy.