Get Procedure Checklist Chapter 23 Using A Volume-control

Filling out the Procedure Checklist Chapter 23 Using A Volume-Control is essential for ensuring safe and effective administration of medications via volume-control administration sets. This guide will walk you through each step of the process, making it straightforward and accessible for users of all experience levels.

Follow the steps to fill out the procedure checklist effectively.

1. Press the ‘Get Form’ button to access the Procedure Checklist Chapter 23 and open it in your online document editor.
2. Begin by reviewing the medication guidelines outlined in the form. Ensure that you understand the steps to follow for all medications to ensure safe administration.
3. Prepare the volume-control set tubing. First, close both the upper and lower clamps on the tubing.
4. Open the clamp of the air vent on the volume-control chamber as indicated in the procedure checklist.
5. Maintain a sterile procedure by attaching the administration spike of the volume-control set to the primary IV bag.
6. Fill the volume-control chamber with the required amount of IV solution. Open the clamp between the IV bag and the volume-control chamber to facilitate filling. Once the precise amount is in the chamber, close the clamp.
7. Prime the remaining tubing by pinching the drip chamber of the volume-control set until it is half full. Open the clamp below the chamber and run the IV fluid until all air is expelled from the tubing.
8. Recheck the volume in the chamber. If additional fluid is needed, add more solution until you reach the desired amount.
9. Connect the end of the volume-control IV line to the patient’s IV site. This can be done by attaching it directly to the IV catheter, to extension tubing, or to the closest injection port.
10. If using an injection port, cleanse it thoroughly with an alcohol or other antiseptic wipe before attaching.
11. Cleanse the injection port on the volume-control chamber to maintain sterility.
12. Attach the medication syringe, preferably using a blunt, needleless device, and inject the medication directly into the solution in the chamber.
13. If a needle was used, be sure to dispose of the syringe and needle in accordance with safety guidelines.
14. Gently rotate the chamber to ensure that the medication is well mixed within the IV solution.
15. Open the lower clamp to start the infusion at the appropriate flow rate as indicated.
16. Label the volume-control chamber accurately with the date, time, medication details, doses added, and your initials per agency policy.
17. After the medication has completed infusion, add a small amount of the primary fluid to the chamber and flush the tubing. Use double the volume stated in the tubing’s specifications as your flush volume.

Complete your document online to ensure accurate and efficient medication administration.