Get Thermoflex Plus Instructions

Filling out the Thermoflex Plus Instructions online can be a straightforward process if you follow a few simple steps. This guide will provide you with detailed, easy-to-understand instructions to ensure you complete the form accurately and efficiently.

Follow the steps to successfully fill out the form.

1. Click ‘Get Form’ button to obtain the Thermoflex Plus Instructions and open it in your preferred editing tool.
2. Begin by creating your artwork in a suitable software program for your vinyl cutter. Be sure to reverse the image before sending it to the cutter.
3. Once your artwork is ready, load the vinyl sheet into the cutter with the color or shiny side facing down. Remember that you are cutting in reverse, so double-check your setup.
4. Adjust the cutter settings as necessary, as they may differ based on the cutter being used and the sharpness of the blade. It is advisable to perform a test cut before proceeding with the full design.
5. After cutting, use a weeding tool to remove excess material. A helpful tip is to start weeding from the outside and work your way in towards the design.
6. Next, load your garment onto a heat press and place the weeded design with the liner or shiny side up. Set the heat press to the appropriate temperature of 330 degrees.
7. Press the design onto the garment with medium, even pressure for a duration of 15 seconds. Once complete, peel the design away either warm or cold in one smooth direction.
8. Finally, remember to wait 24 hours before washing your garment for the first time. When laundering, wash warm and tumble dry normally to maintain the design.

Start completing your Thermoflex Plus Instructions online today!