Get Lube Sentinel Ii Monitor - Graco Inc

The Lube Sentinel II is a highly configurable micro-processor based monitor designed to detect lubrication flow variations in various systems. This user-friendly guide will walk you through the process of filling out the Lube Sentinel II Monitor online, ensuring accurate setup for optimal performance.

Follow the steps to effectively complete the Lube Sentinel II Monitor online.

1. Click ‘Get Form’ button to obtain the form and open it in the editor.
2. Begin with the configuration of Zone 1. This section allows you to enable the zone and set your desired parameters.
3. Select the units of measure for lubrication (e.g., ounces, pints, gallons). This selection can vary between zones.
4. Input the total quantity of lubricant volume for calibration. This is critical for determining proper functioning during lubrication cycles.
5. Set the flow alarm parameters. Choose between low flow, high flow, or both. Enter the respective limits based on your system's requirements.
6. If applicable, enable the tachometer function, which allows for dynamic alarm adjustments based on machine speed.
7. Proceed to configure Zone 2 in the same manner as Zone 1, ensuring correct input for all parameters.
8. After configuring zones, move to the Serial Port settings if there’s a serial connection required.
9. Finalize by reviewing Global Settings, including fault configurations and alarm conditions.
10. Press the 'RST/CLR' button to exit programming mode. Confirm if changes should be saved; select 'Yes' to finalize.

Complete your document online to ensure your Lube Sentinel II Monitor is accurately configured.