Get Ab-083fa Guide For Completing Form Ab-83f - Absa - Absa

This guide provides comprehensive instructions for completing Form AB-83F, which is essential for documenting pressure piping construction and test data. Users can follow the steps outlined to ensure accurate and compliant submissions when filling out the form online.

Follow the steps to complete the form correctly.

1. Click the ‘Get Form’ button to access the form and open it in your preferred editor.
2. Check the box indicating whether the report is a final data report or a partial data report based on your situation.
3. Enter the name of the contractor responsible for constructing the pressure piping.
4. Provide the address of the aforementioned contractor.
5. Indicate the job number assigned by the end user.
6. State the name of the contractor who sublet the work, or check the N/A box if applicable.
7. Fill in the address of the subcontractor listed in the previous step, or leave it blank if the N/A box was checked.
8. Submit the end user's name and address.
9. Indicate the installation location of the piping system.
10. Provide the piping system design registration number if it applies; otherwise, indicate N/A.
11. If the design work was subcontracted, ensure to check the applicable box confirming the owner's responsibility.
12. Check the box if the contractor who manufactured the piping also designed it.
13. List the welding procedure specification (WPS) numbers for all procedures used; if space is insufficient, utilize the Remarks section.
14. Select the applicable code for construction, such as ASME or CSA Z662 Code.
15. Mark the service category relevant to ASME B31.3 piping systems.
16. Provide any applicable numbers.
17. Specify the fluid for which the piping system was designed.
18. Indicate the design pressure of the piping system.
19. List the maximum and minimum design temperatures for the pressure piping.
20. Enter the test pressure and test medium, marking N/A if not applicable.
21. Specify the material specification and grade of the pipe used.
22. Indicate the corrosion allowance if relevant; otherwise, enter 0.
23. Provide the nominal pipe size and schedule, or if tubing is used, the tube outer diameter.
24. List the flange material and rating; enter N/A if no flanges are present.
25. Indicate any design post weld heat treatment and preheat requirements.
26. State the applicable type(s) of nondestructive examination (NDE) with standard abbreviations.
27. If additional information is necessary and does not fit, attach a separate sheet and refer to it in the form.
28. Complete any remaining information required in the form.
29. Ensure the authorized representative, an employee of the contractor, completes this section.
30. For piping constructed outside of Canada, make sure both an Authorized Inspector and Owner’s Inspector sign the Certificate of Inspection.

Complete your AB-83F document online today to ensure compliance and efficiency.