Get Installation Omega 3000 And 5000 Controllers - Federal Signal

This guide provides essential instructions for users on how to accurately complete the INSTALLATION form for Omega 3000 and 5000 Controllers. By following these steps, you will ensure that your form submission is streamlined and correct, allowing for efficient installation of these important devices.

Follow the steps to complete the INSTALLATION form efficiently.

1. Click ‘Get Form’ button to access the INSTALLATION form, which can then be opened in your preferred editor for editing.
2. Ensure you review the general information section, which outlines essential installation connections for both the Omega 3000 and 5000 models.
3. Fill in the mandatory connections for the Model 3000, ensuring all required connections are marked as mandatory for proper operation.
4. If utilizing the siren kill feature, connect the Brown wire to the vehicle wire that links the Park/Neutral switch to the vehicle computer.
5. For Model 3000, if air horn control is desired, install a low current pushbutton switch and connect its terminal to the vehicle chassis using 18 ga. wire.
6. For the burglar/heat alarm feature applicable to all models, refer to the Omega 90 Manual to understand how to configure this alarm system.
7. Locate the microphone connection and make sure it is properly configured, following the specific diagrams provided in the installation guide.
8. After completing all necessary connections, double-check all wiring and configurations to ensure they align with the guidelines before finalizing your form.
9. Once all information is accurately entered, users can save any changes, download, print or share the form as needed.

Complete your INSTALLATION form online today to ensure proper setup of your Omega 3000 and 5000 Controllers.