Get Ecoblue Advance Combi User Guide - Baxi

Leaving a boiler 'on', in standby mode all day will not cause any problems or use much energy at all. It is only when the boiler fires that it uses energy. The reason you have the boiler on is to make your home warm. This is important, especially during winter, when the temperatures really drop low.

Regularly check the water pressure in the system (recommended pressure is 1.5 bar).

0:00 1:52 How to - operate Combi Boiler - YouTube YouTube Start of suggested clip End of suggested clip Coming from the boiler to heat the radiators. We have minimum then e for economy. And then maximumMoreComing from the boiler to heat the radiators. We have minimum then e for economy. And then maximum ideally you want the dial to be on the e setting to run it most efficiently.

0:03 2:20 Baxi 830 Combi boiler - How to use - YouTube YouTube Start of suggested clip End of suggested clip This is the pressure gauge pressure should be between one and two if the pressure does drop belowMoreThis is the pressure gauge pressure should be between one and two if the pressure does drop below one we can follow the instructions to pull the green lever underneath the boiler.

For a modern combi boiler, the radiator heating temperature should be set for a flow temperature of between 60 and 70°C. Any higher than this and the boiler won't enter condensing mode and be at its optimum efficiency and performance.

To reset the boiler, simply press the reset button until the red light goes away. If your timer is calling for heat, the burner light will come on to indicate the boiler has fired up and is heating your system. If lockout occurs frequently a fault is indicated and you should contact your installer or service engineer.

To reset the boiler press and hold the reset button for a minimum of 5 seconds, then release. If the process is successful the boiler will reset and operate as normal. If the process fails the boilers status signal button will revert to the red flash's.