Get And Lube Sentinel Ii Monitor Operation And Programming

The Lube Sentinel II is a sophisticated microprocessor-based monitor designed to enhance lubrication management across various systems. This guide will provide you with clear and concise instructions for filling out the operation and programming form online, ensuring you can effectively manage lubrication tasks with ease.

Follow the steps to fill out the Lube Sentinel II Monitor Operation and Programming form.

1. Click ‘Get Form’ button to obtain the form and open it in the editor.
2. Identify the section labeled 'Configuration? Zone 1.' Press the PRGM button to access the options for Zone 1. Here, you will have options such as 'Enable Zone,' 'Units of Measure,' and 'Port Total.' Use the SLCT button to toggle through these options.
3. For 'Enable Zone,' select YES or NO to activate the zone. Move to the next option by pressing the PRGM button.
4. In 'Units of Measure,' choose the desired unit (ounces, pints, gallons, etc.) by pressing the SLCT button to toggle through the choices. Once selected, press PRGM to continue.
5. In 'Port Total,' enter the quantity of lubricant delivered per cycle of the divider valve. Calculate this based on your specific system and ensure it is accurate before proceeding.
6. Next, configure 'Fault Setup' by toggling between INTERLOCKED, INDEPENDENT, or DISABLED alarms using the SLCT button. Confirm your selection by pressing the PRGM button.
7. Adjust other settings, including 'Flow Alarm On,' 'Low Flow Set,' and 'High Flow Set,' following the same toggle and confirm method. Press the PRGM button to advance through these options.
8. If applicable, configure the parameters for 'Tachometer' settings, and ensure you correctly enter 'Set # Pulses/Rev' and 'Set Normal RPM.'
9. After configuring Zone 1, toggle to 'Configuration? Zone 2' to make any necessary changes, following the same instructions as in Zone 1.
10. If there are no updates for the serial port settings, move on to 'Global Settings' and complete these configurations as needed.
11. Once all settings are complete, press the RST/CLR button to exit programming mode. You will be prompted to save your changes. Use the SLCT button to confirm YES, and then press the PRGM button to finalize your inputs.
12. Review the form for any errors and then you can save changes, download, print, or share the form as required.

Complete your documents online to ensure efficient and effective operation of the Lube Sentinel II.