Get An118 -- Flash Programming Of Cc253x/4x Devices. Application Reports

This guide provides detailed instructions for completing the AN118 application report, which addresses the flash programming of CC253x and CC254x devices. Following these steps will help users navigate each section effectively.

Follow the steps to fill out the AN118 application report.

1. Click the ‘Get Form’ button to obtain the AN118 application report and open it in your preferred editing environment.
2. Read the introduction section carefully to understand the scope and objectives of the document. This will give you context on the flash programming process.
3. Proceed to the abbreviations section to familiarize yourself with the specific terms used throughout the document. This will help ensure clarity as you continue.
4. Review the hardware setup instructions. Ensure that all necessary components are prepared and properly configured before beginning programming.
5. Follow the steps outlined for entering debug mode. This includes specific commands and sequences that will prepare the device for programming.
6. Utilize the chip erase instruction to clear flash memory. Ensure you follow the correct sequence to avoid any errors.
7. Next, implement the write flash memory procedure. This portion details the use of DMA and proper configurations for writing to flash memory. Take care to complete each sub-step accurately.
8. Finally, after completing the programming, read back from the flash memory to verify that the correct data was written. Follow the instructions for reading back effectively.
9. At the end of the process, remember to save changes to the document. Depending on your needs, you can also download, print, or share the filled form.

Complete your flash programming tasks efficiently by following the AN118 application report online.