Get Sta Rite 53185

Typically a spider gasket will last 5 to 10 years before needing a replacement. sections to be connected without bleeding over to other sections. Changing out the Spider gasket and lubricating the shaft of the Multiport valve will make the Multiport Valve operate like a new one again.

1:28 4:20 How to: Replace a Spider Gasket on a Multiport Valve - YouTube YouTube Start of suggested clip End of suggested clip Use your fingers or some needlenose pliers to remove the worn. O-ring clean any foreign materialMoreUse your fingers or some needlenose pliers to remove the worn. O-ring clean any foreign material from the gaskets. Groove. This ensures that when we the new gasket it is sitting cleanly.

There are many different things you can use to a spider gasket. Lot of people use silicone. It does need to be applied carefully so it won't get everywhere. Some people use grease, gasket adhesive, and of course super glue and crazy glue.

Getting worn or damaged pool spider gaskets would usually cause leaks around the multiport valve. A port that is intended for filtration may release water that comes from the waste line.

1:35 2:21 How does my multiport valve work? - YouTube YouTube Start of suggested clip End of suggested clip But discharges out the backwash port. The waste setting is used to discharge dirty water from theMoreBut discharges out the backwash port. The waste setting is used to discharge dirty water from the pool. Without going through the filter water flows from the main intake directly to the backwash.

It is not uncommon to see a single rubber spoke from the gasket lift from the grooved area and allow water to go in directions that it shouldn't go. When that happens, this too will often allow sand to come back into the pool. The solution in this case is simple. Replace the spider gasket.