Get Usda Form Psp 4200

Filling out the Usda Form Psp 4200 online is a straightforward process that requires attention to detail to ensure accuracy. This guide provides comprehensive instructions to help you complete each section of the form effectively.

Follow the steps to fill out the Usda Form Psp 4200 online successfully.

1. Press the ‘Get Form’ button to access the form and open it in your preferred editor.
2. Begin by entering the information for the scale test agency, including the name, address, city, state, zip code, phone number, and email address.
3. Enter the scale owner's name and their address details, ensuring to include the city, county, and state. If needed, provide directional details on an additional sheet.
4. Fill in the manufacturer's name of the beam, dial, or digital indicator.
5. Input the model number of the indicator as it appears on the manufacturer’s ID plate.
6. Provide the serial number of the indicator found on the ID plate.
7. Indicate the type of indicator by checking the appropriate box and specify if it has printing capabilities.
8. Enter the name of the manufacturer of the balance indicator installed on beam scales.
9. If applicable, input the depth of the pit in feet for below-ground indicators.
10. Describe the type or design of the lever system by entering one of the specified descriptions.
11. State the total scale capacity in pounds (maximum nominal capacity).
12. Enter the minimum scale division quantity in pounds.
13. Indicate if the scale is non-marked, or marked III or III L.
14. First, measure and enter the length and width of the platform. Next, calculate the platform size by multiplying these dimensions.
15. Use the provided chart to determine and enter the scale capacity based on the platform size.
16. List the category of livestock that are weighed.
17. Check the boxes for any accessories that are part of the scale.
18. Provide your observation on the accessibility of the scale for testing.
19. Enter the date when the scale was tested.
20. Document the date of the last scale test.
21. Assess and state the condition of parts of the scale.
22. Record the test results entered by the state official or testing company.
23. Detail the sensitivity response for beam scales or the discrimination for dial and digital scales in pounds.
24. Enter the range for motion detection.
25. Specify the range for the auto zero functionality.
26. Fill in the test data in sequence and record information on location, total test weights, correction weights, error weights, and calculated error.
27. If applicable, input the results for the decreasing load test.
28. Use the remarks section for any necessary comments or explanations.
29. The recipient must sign to acknowledge receipt of the test report.
30. The inspector or person testing the scale must also sign the form.

Complete your Usda Form Psp 4200 online today with confidence!