Report Break Article For Free

Breaking Out of For Loops. To break out of a for loop, you can use the endloop, continue, resume, or return statement. endfor; If condition is true, statementlist2 is not executed in that pass through the loop, and the entire loop is closed.

EXIT is used to end the processing within an AL trigger. EXIT works the same, regardless of whether it is executed within a loop. It can be used to end the processing of the trigger or to pass a return value from a local function.

An exit statement is used to interrupt the execution of an AL trigger. The interruption occurs even when the code is executed inside a loop or a similar structure. The exit statement is also used when a local method should return a value.

This function allows us to RESET , that is, clear, all filters that are currently applied to a record. RESET also sets the current key back to the primary key, removes any marks, and clears all internal variables in the current instance of the record.

The SKIP Function (Report, XMLport) allows you to conditionally skip processing of the current report or XMLport. If the processing occurs inside a loop, the processing continues with the next record after the SKIP Function (Report, XMLport) is called.

You can also use the AL BREAK Statement to exit an iteration or loop. The difference is that the BREAK statement does not terminate the trigger. It just exits the loop.

BREAK causes the current trigger to end. When used inside a loop, such as a WHILE-DO or REPEAT-UNTIL construction, BREAK interrupts the loop and causes the current trigger to end. Compare this with the QUIT Function (Report, XMLport). You can also use the C/AL BREAK Statement to exit an iteration or loop.