Get Franklin Electric Aim Manual

ing to the manual the MAIN winding should have a reading of between 3.0 and 3.6 ohms between the YELLOW and BLACK wires, which are the main winding readings. The START windings are the reading between the YELLOW and RED wires. The range should be between 10.7 and 13.1 ohms.

The serial number on all Franklin Electric motors can be found etched/engraved into the motor stator shell, just above the etched nameplate information. The first two digits in the date code represent the year of manufacture, with the third being the month of manufacture.

Faulty Submersible Pump Signs Broken Seal: Often, lack of pressure suggests that the pump needs refilling with water. ... Low Pressure: ... Air in the Pipes: ... Leakage: ... Continuous Running Pump: ... Poor Water Pressure: ... Strange Noise: ... Water Contamination:

How Many Amps Does a 2 HP Well Pump Use? As for a 2 HP well pump, it will use about 16.25 amps when running on a 120-volt system and 17.73 amps when connected to a 110-volt circuit. The amperage draw is obviously lower when the voltage is increased to 240 volts at just 8.13.

2:16 3:41 How to Troubleshoot Submersible Motors with Your Ohmmeter YouTube Start of suggested clip End of suggested clip See the cable resistance table in the pocket service manual for reference. To measure line-to-groundMoreSee the cable resistance table in the pocket service manual for reference. To measure line-to-ground resistance with a basic digital ohmmeter. First ensure there is no power to the motor measure.

Quick Disconnect (QD) boxes make trouble shooting simple by automatically disconnecting the control components from the system when the lid is removed. Solid state switching, with the QD Relay, provides longer life than voltage relays, and improves the operation of the system.

The reading should be between 0.3 to 2 ohms. If it is 0, there is a short. If it is over 2 ohms or infinite, there is an open. You can also dry the connector and retest to possibly get more accurate results.